![]() ![]() ![]() A dash pattern is superimposed on the line. ![]() A line is considered to be of infinite length.If you can’t find it, you may need to change pattern type to user-defined. Click OK to accept this changes, then when you activate hatch command, you should see it in your pattern list. In files tab, below support file search path, add your folder. It is used only for dashed lines.ĭelta-y value indicates the spacing between members of the family that is, it is measured perpendicular to the lines. Open AutoCAD options (type OP then enter). Each pattern line is considered to be the first member of a line family, created by applying the delta offsets in both directions to generate an infinite family of parallel lines.ĭelta-x value indicates the displacement between members of the family in the direction of the line.Blank lines and text to the right of a semicolon are ignored.However, you must begin a pattern definition with a letter or number, not a special character. You can include letters, numbers, and the special characters underline (_), hyphen (-), and dollar sign ($). Each line in a pattern definition can contain up to 80 characters.Hatch pattern definitions follow these rules: This simple pattern definition specifies a line drawn at an angle of 45 degrees, the first line of the family of hatch lines is to pass through the drawing origin (0,0), and that the spacing between hatch lines of the family is to be 0.125 drawing units. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |